The Street > The Bike Shop

odyssey quik slic cable

(1/10) > >>

laloest33:
has anyone tried using one of these.  I am unfortunate enough to have a frame that isn't quite compatable because the cable stop is welded too close to the seat mast.  The problem I'm having is that i had to use the knarp that's included to shorten the cable up.  the knarp fits into my odyssey brake lever, but I cant get it to go deep enough for the cable to twist into the barrel slot.

i know all of this is hard to put into words so i'll try to post pics up later.  i just thought i'd post this to see if anyone knew what i'm talking about..

here is a link from odyssey's website.  their example seems to be working fine.

KillSeth:
It fit fine when I used it with my Odyssey lever.
Kind of a silly question but are you sure it is facing the right way? If I remember correctly, that hole is not in the center of the knarp so you want to make sure that it is rotated with the grub screw on the outside.

laloest33:
I have the same lever as the picture.  

as for your second comment, yeah, i tried fitting it in both ways.

laloest33:
i was even thinking of drilling the hole in the brake lever all the way through.  this would let me fit the knarp in deep enough but i shouldnt have to do that.  the illustration seems to work fine.

skateparkrider:
There might be a chance that your knarp is a defect.  It would be worth calling (or emailing if you are non US) the warranty guy.

Navigation

[0] Message Index

[#] Next page