The Street > The Bike Shop
definitive freecoaster thread
Nutbaggs:
--- Quote from: Spev;3543383 ---My little contribution.
This is a Affix/KHE style coaster I machined down.
I turned down the non drive side flange and re-drilled the holes.
I femaled the axle and extended the thread in the non drive side so the thicker cone nut can be replaced by a thinner one giving more room for a hub guard. I also made a narrower non drive cone to give more room as well.
It has a thrust bearing behind the clutch, and I've been looking into bushings for the driver.
The lower shots have older B6 ti bolts.
--- End quote ---
Kinda similar to a Greyhound then I guess. I regards to the shell anyway.
condrbkr:
So how can I make my Reverse crank flip?
super_chief:
--- Quote from: condrbkr;3546375 ---So how can I make my Reverse crank flip?
--- End quote ---
dead on chain alignment.
ensure driver bearings spin glass smooth (replace frequently)
add axial thrust bearings behind the clutch
condrbkr:
Will I be able to crankflip on the Ratchet?
super_chief:
should be able to, yes
the original version (first came out) had too tight a clearance between hub shell and chain which caused drag (i found out first hand). those hubs should be long gone unless there's one collecting dust out there in a bike shop
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version