The Street > The Lounge
What have you made?
hugh.:
Rad. Are you going to make more?
KillSeth:
--- Quote from: Dr. Steve Brule on February 02, 2015, 08:31:08 AM ---
--- Quote from: KillSeth on February 02, 2015, 08:03:18 AM ---I made a couple of headtube badges recently:
Now, someone let me know a good, consistent way to bend these to fit a 1 1/8" headtube.
--- End quote ---
--- End quote ---
What am I looking at there? One pipe nested within a slightly larger pipe?
I suppose I could sandwich the whole thing between two boards with a bolt on either end to crank down on, right?
Dr. Steve Brule:
Yeah, basically a half pipe and inner pipe, pop it in a press or vice, should do the trick.
blueee:
first time really doing anything with wood, it was really fun
first this bike rack
then this loft
aside from three new 2x4's and a 2x8. most the matierials came from just scrap i saw laying around over the course of a couple days, haha
i still need to install a banister from the oakland unified school district covered in all the youngsters musings, haha. its going to rest on the 2x4s hanging off. i found it while checking out a ledge in front the school omw to a superbowl party.
those long timbers came from a huge pallet a couple blocks down my street
blueee:
pokies
i hit a bunch of spokes with an angle grinder
I want to melt little nifty things onto the J's
my roommate bought a bunch of army men!
and then threw them away the next day!!!
also use spokes as hairpins, pretty nifty methinks
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version