The Street > The Lounge
What have you made?
Prodigal Son:
Carlos what did you get your degree in?
Cole:
--- Quote from: Prodigal Son on February 07, 2015, 01:36:13 AM ---Carlos what did you get your degree in?
--- End quote ---
Majored in slaying pussy, minored in keeping it real.
Eggit2:
--- Quote from: KillSeth on February 02, 2015, 08:39:01 AM ---
--- Quote from: Dr. Steve Brule on February 02, 2015, 08:31:08 AM ---
--- Quote from: KillSeth on February 02, 2015, 08:03:18 AM ---I made a couple of headtube badges recently:
Now, someone let me know a good, consistent way to bend these to fit a 1 1/8" headtube.
--- End quote ---
--- End quote ---
The badge might spring back a bit, so you may need to use an inner tube with an ID slightly larger than 1-1/8", may take a bit of experimenting.
What am I looking at there? One pipe nested within a slightly larger pipe?
I suppose I could sandwich the whole thing between two boards with a bolt on either end to crank down on, right?
--- End quote ---
Brooklynrider:
Made this rack out of broken frames I had laying around the shop. Nothing compared to what some of you guys posted on here.
MilkyWilky:
--- Quote from: Brooklynrider on February 08, 2015, 07:02:39 PM ---Made this rack out of broken frames I had laying around the shop. Nothing compared to what some of you guys posted on here.
--- End quote ---
But it's something! 10/10 would load.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version