16
The Lounge / Re: Post Your Edged Weapons Thread
« on: November 07, 2014, 06:29:37 PM »
Ran a batch of these not too long ago for a customer. CTS-XHP blades, 6Al/4V frame and pocket clip. 1/4" pivot on caged bearings.
Multimedia |
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
got a promotion and rewarded myself. i know i know RIA is junk. but out of all the 1911s ive shot i liked this one the most. got a good deal too.
wow, its been a while since anything thing in that picture has happened or even in the same state.
My 10/22 is way different now.
Quoting this from way back because it is badass.
Quoting this from way back because it is badass.
Well, since I've already ordered the 1911 lower and parts kit - what recourse is there if everything ends up being a bag of crap?
If I do one of their build parties I'm assuming I'll know right away if anything is out of spec. Since they're hosting I imagine employees are present; do they just tell you tough luck?
Tell them " Sheepdog sent you", for a little something special |
Click this image for a little something special |