Multimedia

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - @ss4oLe

Pages: 1 2 [3] 4 5 6 7 8 ... 26
31
The Lounge / Re: im driving up the oregon coast
« on: May 03, 2015, 08:55:47 PM »
Wait, did you grab a bunch of the plastic cock rings from the Gravity table?!?!

32
The Lounge / Re: im driving up the oregon coast
« on: May 03, 2015, 03:23:30 PM »
wtf, you were at greenlake?

I was there from 10AM until 7:40PM

did you drag your feet through the berm like every other brakeless kid? :D

33
Riding Photos / Re: Wild Trail setups
« on: April 29, 2015, 09:39:07 PM »
The Greenlake BMX jumps are smack dab in the middle of a city park. We can't just go diggin' holes, etc.

The dirt was given to us from another parks area.

Hopefully there will be some pics and videos from the jam.

34
Riding Photos / Re: Wild Trail setups
« on: April 28, 2015, 09:09:31 PM »
Been riding there 20+ years. Haven't seen anyone hit the fence.

35
Riding Photos / Re: Wild Trail setups
« on: April 27, 2015, 09:13:36 PM »
We're stacking and packing. Strict "no photo's" policy....

We have a public park that just got 27 dump loads of dirt this winter. That place is dialed. Trail jam is this Saturday.

http://canyoudigitbmx.com/greenlake-bmx-jam/


36
Bike Gallery / Re: Trails Not Rails
« on: April 27, 2015, 07:34:43 AM »
Why such a high gear?

You shouldn't have to pedal when riding trails.

Also, post picks of your trails.

37
The Bike Shop / Re: BG "cool" frames
« on: April 09, 2015, 05:46:33 PM »
Grim Reaper, for sure!

I have one for sale.....;) second version/year. great condition... sunday driver, etc.

38
Or just put it together and ride the piss out of it....

39
Either way, really.

40
Lairdframe dot com

41
The Bike Shop / Re: What did you do to your bike today? (v2)
« on: April 04, 2015, 10:29:38 AM »
Rode some dirt jumps.

Swapped out the pinched to hell Freeze stem for a Fedetal stem.

42
The Bike Shop / Re: I Need Help With Dialing In My Rear Brake - Gyro
« on: April 01, 2015, 01:43:25 PM »
No taking out the inner cable on a gyro cable.

43
lairdframe.com

Sucks to pay so much and have stuff not be close to perfect.


44
The Bike Shop / Re: I Need Help With Dialing In My Rear Brake - Gyro
« on: March 30, 2015, 05:55:01 PM »
I ran a gyro for more years than many of the folks on this board have been alive.

We need more information about the condition of your bike but assuming it's not a complete rusted pile of junk and the rear wheel is true, here is what I would do.

take off the cables and spray DW-40 very heavily into the cables. Let them drip onto the ground, outside or onto your carpet...
Let the cables dry and then use Tri-Flow or some other quality cable lube and lube them HEAVILY.

Take the brake arms off and clean the posts and arms well. Clean the springs too. Make sure to remember what spring goes on what side of the arm.

Take the brake pads off and throw them at your cat or into the garbage can.

Put a small amount of grease onto the brake posts and make sure the arms pivot well.

If your rim is chrome, get black pads. If it's not chrome, get clear pads.

Wipe off any excess lube from the cables and replace them.

Clean your rim with glass cleaner or something to remove any old gunk.

adjust the springs on your brake arms.

Put the new pads on.

Go do a fufuanu.


You'll need to adjust the gyro cables at the gyro so the gyro doesn't flop.

If that doesn't fix your braking issues, you could replace the cables. or just put on a strait cable....


If you have more questions, ask.

45
The Bike Shop / Re: Lincoln City Skatepark
« on: March 26, 2015, 04:28:15 PM »
Every small town in Oregon is pretty methy

Pages: 1 2 [3] 4 5 6 7 8 ... 26
-->

Tell them " Sheepdog sent you", for a little something special

Click this image for a little something special
Hello