Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - PatchedTubes

Pages: [1]
The Bike Shop / What did you do to your bike today? (v2)
« on: August 14, 2012, 12:58:34 PM »
painting flat black, waiting for parts in the mail. my s3 hasnt looked so good since it was new, regreasing my trailmix pedals and making all the little other stuff nice and fancy.

The Bike Shop / What did you do to your bike today? (v2)
« on: August 13, 2012, 10:37:13 AM »
sanded the incredible amount of rust off my frame forks and bars for like 5 hours yesterday, bought some paint this morning.

The Lounge / Post Your Guns
« on: June 10, 2012, 12:24:57 PM »
just got a 98k, sweet rifle accurate got a new stock, sight hood, sling i wouldnt buy one made after 1942 as they tend to be a little crude or not made in the mauser factory at all. probably better than the mosin in every way. the stock was terrible and soaked with that cosmoline that russians put on them after they were captured. but it couldnt be any better now picked 1 out of like 30 rifles no pitting in the rifling or wear at all, i remember my brothers nagant had terrible pitting and the diameter of the muzzle was like 2x width of the bullet, i guess the carbine version is nice though but has a decent amount of recoil.

Site Help and Rules / Madera pilot v1
« on: September 20, 2011, 09:53:12 PM »
would profile still make harware for the v1? i had feeling i need shims, they couldnt make it more difficult to get them though, they dont sell them on profile's site. i figure if the inside of the hubshell is the same size/ bearings seats that the mini hardware might fit.

Site Help and Rules / Madera pilot v1
« on: September 20, 2011, 09:25:41 PM »
i have the early version of the pilot front hub; my question is would the internals for the mini front hub fit in the v1 hubshell? the hardware on my front hub seen better days and i dont think they make the old hardware anymore. and in the cassette hub there were very thin shims behind the bearings (madera v2) their bent up now are these neccasary for the hub? i read on profile's site there just to compensate for the axles length.

The Bike Shop / What did you do to your bike today? (v2)
« on: September 14, 2011, 11:19:59 AM »
put a playing card in the front wheel, raised my seat a little,tightend up my hubs/cranks.

Riding Photos / Wild Trail setups
« on: June 18, 2008, 04:20:31 PM »
Quote from: slingazz;2513226

hurts my brain,those things are big yet look soo small.

Riding Photos / Wild Trail setups
« on: May 15, 2008, 05:16:09 PM »
i cant build trails in my town being that the soil is made up of 50% rocks and the other 50% rock hard clay.=/

Site Help and Rules / Selling
« on: November 13, 2007, 08:46:21 PM »
first post and already selling stuff.questionable???

Sell and Swap / Trusted/Un-trustworthy sellers
« on: July 29, 2007, 12:41:22 PM »
has anyone ever dealt with biggie c seems like a trustworthy guy?

Pages: [1]

Tell them " Sheepdog sent you", for a little something special

Click this image for a little something special