Multimedia

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Admiral Ackbar

Pages: 1 ... 5 6 7 8 9 [10] 11 12 13 14 15 ... 36
136
The Lounge / Re: Post Your Guns
« on: July 15, 2013, 08:10:30 PM »
got to shoot one of those mosin nagants this winter. good fun

137
The Bike Shop / Re: What did you do to your bike today? (v2)
« on: July 08, 2013, 02:40:38 PM »
rode that shit

138
The Bike Shop / Re: Quick Questions
« on: May 31, 2013, 10:54:18 PM »
phil wood definitely makes flip/flop fixed/free hubs. and fyi you can thre
Do Phil Wood make a track rear hub with a fixed cog on one side and a freewheel on the other? I can't see anything on their site.

When putting barend brakelevers on bullhorn bars does the cable go inside the bar and would I need to drill a hole for it to go to the callipers?

PW fixed/free hub 120 spaced : http://www.bikeman.com/BTI-PW81236.html?
utm_source=GoogleBase&utm_medium=GoogleBase&utm_campaign=GoogleBase&gclid=CIyWnfT5wbcCFQbNOgoda0cAFg

cable routing is all down to the bars, if theres two holes near the stem, run it internally, if not go under the tape

139
The Lounge / Re: Steven Hamilton
« on: May 28, 2013, 10:22:33 PM »
QSS 5 has some realll good footy of him

140
Riding Photos / Re: Official Table photo thread.
« on: April 28, 2013, 08:10:44 PM »

141
The Bike Shop / Re: What did you do to your bike today? (v2)
« on: April 21, 2013, 04:17:38 AM »
RIP.

142
The Lounge / Re: What have you made?
« on: April 15, 2013, 07:50:03 PM »
those toiletry bags are very nice looking

143
Riding Photos / Re: Official Table photo thread.
« on: April 14, 2013, 07:54:31 PM »
instagrabbed. hammy throwin down


144
The Bike Shop / Re: What did you do to your bike today? (v2)
« on: April 12, 2013, 06:25:16 PM »
went to take it out of my car at the skatepark then i noticed my front axle was broken. 2nd wheel I've broken in less than a month... time to buy a female hub

145
The Bike Shop / Re: What did you do to your bike today? (v2)
« on: April 12, 2013, 03:53:16 PM »
that intrakat is outta control ! fuck

146
The Bike Shop / Re: What did you do to your bike today? (v2)
« on: April 06, 2013, 01:17:09 AM »
been getting so many damn flats :( didn't get a single one for like 2 years and then now I've had 4 in a week.

147
Riding Photos / Re: Official Table photo thread.
« on: April 02, 2013, 07:41:09 PM »


because ratboy

148
The Bike Shop / Re: What did you do to your bike today? (v2)
« on: April 02, 2013, 06:27:34 PM »
I decided to 4peg it up so I threw my plastics on the rear and went for a shred this afternoon. finally iced this weird ledge I've been trying to get for a while, oppo grinds that use the rear peg feel proper weird though. got a flat eventually but it was getting hot and a bit muggy anyway

been getting pretty consistent with my go-to tricks and one by one I'm knocking my to-dos out. learned feebs and pegs to reg 180, feebs to tooth (sorta). want to learn proper straight tooths down hubbas at some point. also wanna get luc-e's & nollie pegs in the near future

149
The Bike Shop / Re: Quick Questions
« on: March 21, 2013, 07:37:01 PM »
flatlandfuel has $20 hoffman front hubs

150
The Bike Shop / What did you do to your bike today? (v2)
« on: March 07, 2013, 08:49:15 PM »
clean everything and sand your pads down

Pages: 1 ... 5 6 7 8 9 [10] 11 12 13 14 15 ... 36
-->

Tell them " Sheepdog sent you", for a little something special

Click this image for a little something special