Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Cmb4130

Pages: [1]
The Bike Shop / Mtb crank question for you tech savvy folks
« on: April 19, 2017, 06:17:40 PM »
Pedal snapped off my cranks on Sunday, so I bought new ones. Didn't feel like putting too much effort into the whole thing, so I bought the same cranks (updated ones).

The spindle reads 113mm so I bought the new ones in the same exact 113mm size but they don't fit the same as the last pair.

There is 2mm of slack in spindle when I slide them on.

How could this be? They are the EXACT SAME cranks?

The cranks are e*thirteen "the hive" xcx.

I will post pics if my discription doesn't make sense.

Thanks in advance!

Sell and Swap / Odyssey clutch wheel
« on: July 31, 2016, 10:12:23 AM »
Look at this on eBay:

Half the cost of what it would run you to build one up.

Sell and Swap / FS: Flybikes Geo frame 21.3 top tube
« on: July 20, 2016, 05:51:32 PM »
On eBay right now cheap.

Get up on it son!

Anyone know how to make this stop?

Sell and Swap / Need an internal BB spacer (19mm)
« on: May 12, 2016, 06:43:18 PM »
Anyone have one they are willing to sell?

I know everyone will chime in and say it shouldn't make a difference, but I've been running a 10 tooth for the past eight years or so and I can't stand running the 9 tooth. It puts way too much pressure on the chain (being that the rear cog pulls so hard on the rear wheel) and it's impossible to get the chain alignment right without a half link, also rendering the whole rear setup weaker.

9 tooth + half link= going over handle bars.

I love 10-27 gearing and feel much more comfortable knowing that I'm not putting 500-plus pounds of pressure on the smallest point of my rear cog every time I pedal uphill.

The Bike Shop / Spoke size????
« on: January 22, 2016, 07:41:45 AM »
Odyssey clutch hub
Primo Vs. rim.

The hub has two different flange sizes.

Anyone know what approximate spoke sizes I need?

Sell and Swap / Anyone have a chrome rim for sale?
« on: January 05, 2016, 06:49:12 AM »
Need a 36 hole.

Sell and Swap / WTB: Subrosa DTT
« on: November 27, 2015, 08:17:10 AM »
Dual top tube. Anyone know where I can find one of these?

The Bike Shop / Freecoaster enthusiasts... Help me please
« on: August 22, 2015, 05:09:51 PM »
Why can't I find a 10 tooth driver for my KHE greyhound?

A few years back you could get 9,10 and 11 tooth drivers for the KHE line of freecoasters.

Can anyone help me find this diamond in the rough? I'm willing to pay a decent amount. I hate 9 tooth drivers as they out way too much pressure on my chain causing me to rip through them too often.

Sell and Swap / FS: sweet wheel set (madera, odyssey)
« on: June 20, 2015, 11:37:00 AM »

On eBay right now, but willing to sell on here obviously. I hate paying eBay fees.

120.00 shipped.

The Bike Shop / KHE Greyhound freecoaster?
« on: January 04, 2015, 10:55:55 AM »
These seemed solid. Why dont any shops have them? Particularly the female street version.

I'm looking to go backwards and these seemed like the most logical ones to go with considering I had nothing but good times on my Geisha hub back in 2008.

Any thoughts?

Pages: [1]

Tell them " Sheepdog sent you", for a little something special

Click this image for a little something special