Bikeguide.org - Bike maintenance for BMX'ers
The Street => The Bike Shop => Topic started by: MilkyWilky on March 30, 2017, 03:42:04 PM
-
Just curious if the documentation for these standards is out there for people to use, or if it's the whole licensing deal, or is it me & calipers?
TNXXx
-
Good question. I know the Socket drive specs are available for free so people can build sprockets to fit, but I couldn't find a spec sheet for Tripod. I'd check with OTX distro--they should be able to point you in the right direction.
Is G still on here?
-
Try the contact here - http://www.tripodseatsystem.com/
I doubt anyone will give you anything for free unless you're going to make an order but it can't hurt to try.
-
Pivotal is, or at least used to, be patent protected. So I doubt they would just give it out for people to use without contacting them first for licensing.
Dont know about Tripod. Are people using tripod systems? I have only seen them in ads, never seen anyone riding it.
-
Pivotal is, or at least used to, be patent protected. So I doubt they would just give it out for people to use without contacting them first for licensing.
Dont know about Tripod. Are people using tripod systems? I have only seen them in ads, never seen anyone riding it.
Ive got a tripod set up, theyre not too bad just a little limited with the seat angles and thats about it. They're lighter and slam lower in the seat tube.
-
I use Tripod on 2 of my 4 bikes. I like that there is no hole on top of the seat and the base of the seat is cleaner.
-
I am also confused about that.