Bikeguide.org - Bike maintenance for BMX'ers

The Street => The Bike Shop => Topic started by: Cmb4130 on April 19, 2017, 06:17:40 PM

Title: Mtb crank question for you tech savvy folks
Post by: Cmb4130 on April 19, 2017, 06:17:40 PM

Pedal snapped off my cranks on Sunday, so I bought new ones. Didn't feel like putting too much effort into the whole thing, so I bought the same cranks (updated ones).

The spindle reads 113mm so I bought the new ones in the same exact 113mm size but they don't fit the same as the last pair.

There is 2mm of slack in spindle when I slide them on.

How could this be? They are the EXACT SAME cranks?

The cranks are e*thirteen "the hive" xcx.

I will post pics if my discription doesn't make sense.

Thanks in advance!

Title: Re: Mtb crank question for you tech savvy folks
Post by: LeonLikesToRock on April 19, 2017, 10:13:16 PM

did you use the same spacers/dust cap things off your old cranks/bb?

Title: Re: Mtb crank question for you tech savvy folks
Post by: Cmb4130 on April 20, 2017, 04:25:30 PM

Same spacers.

When I measure the spindle, the one is longer than the other.

Which explains it. But they are BOTH 113mm spindle.

I wish there was a way I could tighten the arms from both sides.

Title: Re: Mtb crank question for you tech savvy folks
Post by: Sasha on April 25, 2017, 04:06:23 PM

Put a 2mm spacer on either the spindle or behind a BB cup if it's threaded. Cycling is fucked and everything is wrong.

Title: Re: Mtb crank question for you tech savvy folks
Post by: MEAT on April 27, 2017, 10:22:10 AM

If they're updated, they're probably 3mm wider to accomodate bikes with boost axle spacing, using a spacer behind the cup, rather than them having to change the design of the spider to push the chainring out the required amount?

Regular Columbo here.