The Street > The Bike Shop
Pivotal and Tripod specs?
MilkyWilky:
Just curious if the documentation for these standards is out there for people to use, or if it's the whole licensing deal, or is it me & calipers?
TNXXx
montymitch:
Good question. I know the Socket drive specs are available for free so people can build sprockets to fit, but I couldn't find a spec sheet for Tripod. I'd check with OTX distro--they should be able to point you in the right direction.
Is G still on here?
LeonLikesToRock:
Try the contact here - http://www.tripodseatsystem.com/
I doubt anyone will give you anything for free unless you're going to make an order but it can't hurt to try.
JFax:
Pivotal is, or at least used to, be patent protected. So I doubt they would just give it out for people to use without contacting them first for licensing.
Dont know about Tripod. Are people using tripod systems? I have only seen them in ads, never seen anyone riding it.
streetStreet:
--- Quote from: JFax on April 03, 2017, 05:28:31 AM ---Pivotal is, or at least used to, be patent protected. So I doubt they would just give it out for people to use without contacting them first for licensing.
Dont know about Tripod. Are people using tripod systems? I have only seen them in ads, never seen anyone riding it.
--- End quote ---
Ive got a tripod set up, theyre not too bad just a little limited with the seat angles and thats about it. They're lighter and slam lower in the seat tube.
Navigation
[0] Message Index
[#] Next page
Go to full version