The Street > The Bike Shop
Odyssey Clutch Teardown?
theboredbmxer:
So the stick-tion of the resistance mech is unaffected by being greased? I assume then the resistance mech is designed to be run wet? Just lookin for the usual G details
Last one, do you have an aluminum or ti axle planned for down the road?
1664:
It would be cool to see a count of free coasters sold from all the brands offered over the years, I don't suppose you could say how many were manufactured
G:
--- Quote from: theboredbmxer on July 26, 2015, 12:22:25 PM ---So the stick-tion of the resistance mech is unaffected by being greased? I assume then the resistance mech is designed to be run wet? Just lookin for the usual G details
Last one, do you have an aluminum or ti axle planned for down the road?
--- End quote ---
The resistance mech should be greased ideally, but it isnt critical, it will work just fine "dry", if there is any grease in the hub then there is nothing to stop it getting into the resistance mechanism so it will likely have some.
No aluminium axle for this and no plans for a Ti one, there wouldn't be much point as the axle really isnt a big part of the weight. A 14mm Ti bolt would probably be worthwhile as there is still plenty of strength and the weight saving is good.
:)
G.
metalbmxer:
--- Quote from: G on July 27, 2015, 10:39:44 AM ---
--- Quote from: theboredbmxer on July 26, 2015, 12:22:25 PM ---So the stick-tion of the resistance mech is unaffected by being greased? I assume then the resistance mech is designed to be run wet? Just lookin for the usual G details
Last one, do you have an aluminum or ti axle planned for down the road?
--- End quote ---
The resistance mech should be greased ideally, but it isnt critical, it will work just fine "dry", if there is any grease in the hub then there is nothing to stop it getting into the resistance mechanism so it will likely have some.
No aluminium axle for this and no plans for a Ti one, there wouldn't be much point as the axle really isnt a big part of the weight. A 14mm Ti bolt would probably be worthwhile as there is still plenty of strength and the weight saving is good.
:)
G.
--- End quote ---
Ah k thanks I was wondering the same thing about axle options for weight savings
I have already searched and found 1 company offering a combo Ti bolt upgrade (3/8 + 14mm). Light Bmx Company. Look on Instagram
streetStreet:
WHAT WOULD IAN DO
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version