The Street > The Bike Shop
Odyssey Clutch Teardown?
MEAT:
Thats really cool, is there a hole in the hub shell to adjust the slack?
LeonLikesToRock:
--- Quote from: MEAT on July 20, 2015, 06:00:28 AM ---Thats really cool, is there a hole in the hub shell to adjust the slack?
--- End quote ---
You can adjust the slack by putting an allen key through it but its primary function is as a speed hole.
montymitch:
I can just see some kid backing that grub screw all the way out and losing it, or worse, screwing it all the way into the hub and losing it. Doesn't look like there are any stops on it to prevent that from happening.
Bristow:
--- Quote from: LeonLikesToRock on July 20, 2015, 07:10:27 AM ---
--- Quote from: MEAT on July 20, 2015, 06:00:28 AM ---Thats really cool, is there a hole in the hub shell to adjust the slack?
--- End quote ---
You can adjust the slack by putting an allen key through it but its primary function is as a speed hole.
--- End quote ---
I laughed way more than I should have at that piece of wit.
dude...:
nice, that resistance mech does look pretty cool. even if they do wear out over time, theyll be easier to replace than the normal khe style ones, plus the wear should be way less cos the load is spread all the way around instead of being focused onto two tiny ball bearings
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version