The Street > The Bike Shop
22mm spline drive sprickets?
streetStreet:
--- Quote from: G on February 17, 2015, 06:56:43 AM ---WARNING!
Putting Taiwan 22mm splined cranks on a Profile 22mm splined axle (or vice-versa) is going to be a massive disaster, they are very different sizes.
:)
G.
--- End quote ---
what about nonagon sprockets, man?
which compnaies utitlize it?
Cellmember:
--- Quote from: G on February 17, 2015, 06:56:43 AM ---WARNING!
Putting Taiwan 22mm splined cranks on a Profile 22mm splined axle (or vice-versa) is going to be a massive disaster, they are very different sizes.
:)
G.
--- End quote ---
Say what now !
G, please explain I appreciate your input, I'm currently on Columns myself with a Stolen 22mm Spindle which is 5-1/2, I swapped out the original Profile 6" for the Stolen mainly because 6" spreads out my arms too much.
Thanks G,
I like saying G.
G:
--- Quote from: Cellmember on February 17, 2015, 04:44:56 PM ---
--- Quote from: G on February 17, 2015, 06:56:43 AM ---WARNING!
Putting Taiwan 22mm splined cranks on a Profile 22mm splined axle (or vice-versa) is going to be a massive disaster, they are very different sizes.
:)
G.
--- End quote ---
Say what now !
G, please explain I appreciate your input, I'm currently on Columns myself with a Stolen 22mm Spindle which is 5-1/2, I swapped out the original Profile 6" for the Stolen mainly because 6" spreads out my arms too much.
Thanks G,
I like saying G.
--- End quote ---
They are both ostensibly 22mm and 48 spline but the teeth are a slightly different angle, and measure significantly differently on major and minor diameters. Didn't you find it felt very bad fitting when you assembled it compared to the old axle??!!?
:)
G.
Cellmember:
--- Quote from: G on February 18, 2015, 04:15:01 PM ---
--- Quote from: Cellmember on February 17, 2015, 04:44:56 PM ---
--- Quote from: G on February 17, 2015, 06:56:43 AM ---WARNING!
Putting Taiwan 22mm splined cranks on a Profile 22mm splined axle (or vice-versa) is going to be a massive disaster, they are very different sizes.
:)
G.
--- End quote ---
Say what now !
G, please explain I appreciate your input, I'm currently on Columns myself with a Stolen 22mm Spindle which is 5-1/2, I swapped out the original Profile 6" for the Stolen mainly because 6" spreads out my arms too much.
Thanks G,
I like saying G.
--- End quote ---
They are both ostensibly 22mm and 48 spline but the teeth are a slightly different angle, and measure significantly differently on major and minor diameters. Didn't you find it felt very bad fitting when you assembled it compared to the old axle??!!?
:)
G.
--- End quote ---
They actually went together really smooth spline sprocket and cranks, though I do prep before I install anything to make sure the process is as smooth as possible, if anything the cranks weren't as hard to install as regular profile where using a installation tool is necessary as for the columns it wasn't needed but I know now exactly what you are talking about because I have had the similar situation with previous cranks, luckily they all worked fine once installed, thanks for the little bit of info G, I'll be sure to use it for the future.
Navigation
[0] Message Index
[*] Previous page
Go to full version