The Street > The Bike Shop
Quick Questions
Zoidberg:
i swapped my trusty attila stem for a brand new sunday freeze stem and now it slips on every single hop
i've re-done it every time it slipped
do i file the bars, inside the stem or both? does that work really?
and for a bonus question, there's no logo etched on the cut outs at the sides so is this a new version or is there a difference?
also, how much gap is the least you can leave inside a fork steerer tube before the threaded bit?
hugh.:
The new one has no logos on the side. It also has a square font on the faceplate. The older one had the rounded classic Sunday font. As far as I know theres no major difference.
Prodigal Son:
The fuck do I get my driver locknut off? Sitting here with a pair of vice grips on the axle, sprayed a little wd40 on it, and tried to do sudden snaps with my wrench. The vice grips slip on the axle before that nut budges.
Trying to put a cult female axle in my mix.
Mychaylo:
couldnt you just knock everything out that way or is the bearing tucked behind the ratcheting ring?
Brooklynrider:
You shouldn't be using your vice grips at all. You can bolt the hub on the outside of a dropout and use an adjustable to get the locknut off. Mix axles have a broach too..
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version