The Street > The Bike Shop
Quick Questions
G:
--- Quote from: hugh. on April 18, 2014, 10:00:40 AM ---
--- Quote from: Admiral Ackbar on April 17, 2014, 04:27:34 AM ---grease anywhere metal contacts metal, threads included
--- End quote ---
Super stupid question now but what about where the stem clamps the steerer tube and where it clamps the bars?
--- End quote ---
Good point. NO don't grease the bar clamp. steerer is fine and aluminium seatpost in a steel frame is a must.
:)
G.
GUMP_:
Besides the 6802 bearings in the cult driver does anybody know the number for the roller bearing and cylinder thingo from a cult coaster driver?
The bit right In front of my driver?
G:
--- Quote from: GUMP_ on April 21, 2014, 05:36:53 AM ---Besides the 6802 bearings in the cult driver does anybody know the number for the roller bearing and cylinder thingo from a cult coaster driver?
The bit right In front of my driver?
--- End quote ---
You going to replace them? Same thing is going to happen.
Just take the pile into your local bearing stockists and have them measure it all up. The inner race is just defined by its dimensions, hopefully it will be off the shelf.
:)
G.
GUMP_:
--- Quote from: G on April 21, 2014, 07:08:38 PM ---You going to replace them? Same thing is going to happen.
Just take the pile into your local bearing stockists and have them measure it all up. The inner race is just defined by its dimensions, hopefully it will be off the shelf.
:)
G.
--- End quote ---
Yeah I had thought of replacing them G thought it might be cheaper than buying a whole new driver.
Also thought it would be quicker to get this mess running again rather than waiting for the gcoaster or the odyssey one
G:
--- Quote from: GUMP_ on April 21, 2014, 11:31:26 PM ---
--- Quote from: G on April 21, 2014, 07:08:38 PM ---You going to replace them? Same thing is going to happen.
Just take the pile into your local bearing stockists and have them measure it all up. The inner race is just defined by its dimensions, hopefully it will be off the shelf.
:)
G.
--- End quote ---
Yeah I had thought of replacing them G thought it might be cheaper than buying a whole new driver.
Also thought it would be quicker to get this mess running again rather than waiting for the gcoaster or the odyssey one
--- End quote ---
I cant fault your logic on either of those. Bearings should be much cheaper than a whole driver (though I have no idea how much a new driver costs) assuming you can get everything out; and definitely quicker. Hopefully the Odyssey one Aaron is on will be out later this year but it is likely to be just in time for Xmas rather than summer.. and obviously that isnt a firm estimate just a wild guess..
:)
G.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version