The Street > The Bike Shop
What did you do to your bike today? (v2)
TCbmx.:
I rawed and polished the Ruben.
I haven't cleared it yet, I'm trying to decide if I want to throw a trans color on it.
Any suggestions on if I should clear it as is or throw down some trans paint?
Boomhauer:
Did you even sand the frame or just buff it?
Boomhauer:
Oh, and I've been gathering up donated / extended loan parts for my good friend who had his bike stolen a little while back, I've got to open up some forks tomorrow and pick up my chainbreaker then all it needs is a tube and a couple washers :D
Today I re-built the freecoaster hub to an Odyssey Hazard Lite rim, installed Primo Stricker PC pedals and prepared it to be ridden tomorrow.
The whole bike is REALLY nice for being "free".
As far as my bike goes, I pulled the wheels off and on between skateparks/heading home and I worked on 2-3 other peoples bikes today along with once again proveing that most of my local bike shop employees know jack shit about bikes.
TCbmx.:
--- Quote from: Boomhauer;3631774 ---Did you even sand the frame or just buff it?
--- End quote ---
No sanding at all it was rawed with stripper and I polished it up with fine steel wool and used mothers polish and a foam buffing wheel and went to town on it.
supergoose:
that looks really nice.
as for the trans color: i think that depends a bit on the parts that you plan to use for the build.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version