The Street > The Bike Shop
What did you do to your bike today? (v2)
farva:
--- Quote from: Wrecked;3496900 ---I made an 11t cog/driver for my King hub. The stock lock-ring is designed to work with a 12t cog at the smallest so I had to turn it down. I don't have access to a lathe so... I built a ghetto jig to mount up on my drill press and used a file to take the material down.
--- End quote ---
you should find an 11t single speed specific cog for that. the lock ring looks sweet!
Admiral Ackbar:
rode it and didn't have to adjust my wheel for once
blueee:
straightend out my bars and pumped up slow leaks
DonKnotts:
Widened to 14mm and deepened my axle slots on my 04 ody flat fork so I could run this brand new 14mm 36 spoke Hoffman wheel I have had laying around for a year. Surprisingly, I didn't notice a weight difference. My front end finally feels solid again. It is amazing what a new front wheel does for the feel of a bike.
Wrecked:
--- Quote from: farva;3502554 ---you should find an 11t single speed specific cog for that. the lock ring looks sweet!
--- End quote ---
Thanks man. The lockring was fun. It's the first time I used my drill press as a lathe. I just rounded out the edges by hand after taking material off. It turned out alright.
No one makes an 11t singlespeed cog that I was able to find. 12t is the lowest.
I know I'm running on less material but I'm going to end up running a 3/32" chain on this bike anyway so it should be alright. I'm hoping this 11t cog won't be on there for too long...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version