The Street > The Lounge
Post Your Guns
TheHouseProduct:
--- Quote from: yacqueli;3629111 ---that all depends on how you run your gun. You shoot 556 or 223 out of your uppers?
--- End quote ---
No it doesn't. The bolt carrier of a blowback gun like 9mm hits the hammer way harder and faster than the comparatively slow bolt carrier of a 223 DI gun. It tends to make hammer pin holes in 9mm lowers elongate. Hence the heavier buffers and ramped bolts in 9mm guns.
master:
I've had this Insight M3 sitting around for a while and I finally got a shotgun mount for it.
yacqueli:
--- Quote from: TheHouseProduct;3629118 ---No it doesn't. The bolt carrier of a blowback gun like 9mm hits the hammer way harder and faster than the comparatively slow bolt carrier of a 223 DI gun. It tends to make hammer pin holes in 9mm lowers elongate. Hence the heavier buffers and ramped bolts in 9mm guns.
--- End quote ---
How was super toss last night?
Either way if 9mm is harder than 556 in a do or piston upper. Fuck running that lower on anything other than 22lr
William:
.223 will do just fine. Haters gonna hate. I'm not running .22lr through this.
Everyone was just as skeptical about material strength when aluminum receivers came out.
This guy wants $800 for this: http://lasvegas.backpage.com/SportsEquipForSale/900-complete-ar15-upper-bcg-and-charging-handle/9114847
Should I do it? That seems high to me.
Rick James:
Would not buy.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version