The Street > The Lounge
Post Your Guns
BOUNCEHOUSE420:
next time sell them as parts kits (floor plates removed) on ebay
sokoloka:
--- Quote from: couch;3617546 ---That and their Rudius paperweights are out of spec, so good luck. They seem to have nonstop issues with their mill/setup/operators. Heard about quite a few AR's being milled out of spec at their build parties as well.
--- End quote ---
Well, since I've already ordered the 1911 lower and parts kit - what recourse is there if everything ends up being a bag of crap?
If I do one of their build parties I'm assuming I'll know right away if anything is out of spec. Since they're hosting I imagine employees are present; do they just tell you tough luck?
couch:
--- Quote from: sokoloka;3618502 ---Well, since I've already ordered the 1911 lower and parts kit - what recourse is there if everything ends up being a bag of crap?
If I do one of their build parties I'm assuming I'll know right away if anything is out of spec. Since they're hosting I imagine employees are present; do they just tell you tough luck?
--- End quote ---
Tons of information on CalGuns. The guy glbtrottr ran the first group buy and it was absolutely shit. He says there are dims that are off but won't say specifically what they are. Any questions asked are replied with pages and pages of text without the answer to the question.
Problem is they rushed the design and didn't prove it out before going into production and selling. Now they are revising after hundreds have been sold out of spec. The jigs also are completely useless.
Tooth Paste:
Takes a couple minutes to reload. (sometimes more, sometimes less, depends on the situation)
BOUNCEHOUSE420:
--- Quote from: couch;3618543 ---Tons of information on CalGuns. The guy glbtrottr ran the first group buy and it was absolutely shit. He says there are dims that are off but won't say specifically what they are. Any questions asked are replied with pages and pages of text without the answer to the question.
Problem is they rushed the design and didn't prove it out before going into production and selling. Now they are revising after hundreds have been sold out of spec. The jigs also are completely useless.
--- End quote ---
haha they called you a hater
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version