The Street > The Lounge
Post Your Guns
master:
--- Quote from: deathrow;3509703 ---^^^
that is a spikes lower correct? i am considering one. how is yours holding up?
--- End quote ---
A lower is a lower. 80% of them are made in the same place, you're just paying for the rollmark.
That being said I've never heard bad things about Spike's lowers.
deathrow:
--- Quote from: zane;3509765 ---A lower is a lower. 80% of them are made in the same place, you're just paying for the rollmark.
That being said I've never heard bad things about Spike's lowers.
--- End quote ---
pretty much what i thought. i know little about ar's but i really want to start building one.
master:
--- Quote from: deathrow;3509767 ---pretty much what i thought. i know little about ar's but i really want to start building one.
--- End quote ---
They are great guns to build. You need some special tools to build the upper (barrel wrench/upper vice block), so I recommend getting a complete upper receiver, a bare lower receiver and a Lower Parts Kit / Stock. One hour build at most.
deathrow:
Thats pretty much the route I was going to take. Thanks for the heads up.
gnar_rider:
anyone have any suggestions for a pistol?
I'm thinking a .40 or 9mm, debating on whether or not getting a gun small enough to conceal/debating how much I want to spend on ammo.
I was really looking into s&w .40 cal, saw they were in the mid 400 dollar range.
anything else i should research? i have been reading everything about every make of pistol I see, are there any to stay away from? any cheaper makes that are worth checking out?
I have a lot of friends with lots of gun knowledge, but I figured I would see what you guys might suggest.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version