The Street > The Lounge

Post Your Guns

<< < (554/863) > >>

master:

--- Quote from: couch;3487679 ---Barrels mist have a permanently attached muzzle device. Basically a blind hole thru the device and into the barrel, a pin pressed in then filled with weld. Must be a minimum of 16" including the device.

The bolt catch can be used exactly the same as without the BAD lever. It allows you to release the bolt and lock it back with your trigger finger as well as retain all standard function. It simply clamps onto the stock catch.

This bullet button shit sucks though.
--- End quote ---


FYI the muzzle device can be Silver Soldered too... blind pins are a PITA.  Only matters if you're building it yourself though.

BOUNCEHOUSE420:

--- Quote from: couch;3487679 ---

This bullet button shit sucks though.
--- End quote ---


honestly i feel like im faster with the bullet button and the Ultimate Bullet Button Tool installed on my mag than with regular mag release....


i also wasnt that stoked on standard cap mags too long to load and empty too fast:D

master:

--- Quote from: couch;3487679 ---This bullet button shit sucks though.
--- End quote ---



--- Quote from: BOUNCEHOUSE420;3487731 ---honestly i feel like im faster with the bullet button and the Ultimate Bullet Button Tool installed on my mag than with regular mag release....


i also wasnt that stoked on standard cap mags too long to load and empty too fast:D
--- End quote ---


I was so confused for a minute until I realized you guys have to deal with all the CA bullshit.........

Fuck that.  Detachable mags FTW.

yacqueli:

--- Quote from: couch;3487601 ---I'd like to keep the entire upper under $800

I'm currently looking at this Rifle Gear Upper and swapping out to a quad rail.


--- End quote ---


Hmmmm I have this upper with a bcm fa bcg

deathrow:
went to a show today. highly stoked on a ruger 44 mag carbine i saw.

Navigation

[0] Message Index

[#] Next page

[*] Previous page