The Street > The Lounge
Post Your Guns
couch:
Pretty sure all of it needs to be done by the final owner.
couch:
Handle this... 60%ish 1911 castings. No machining has been done but some parts are good to go with minimal/zero fitting. This is pretty much what mine started out as but it had a few of the holes finished already. I may pick up one or two of these...
http://www.gunco.net/forums/f259/fs-60ish-1911-castings-55389/
BOUNCEHOUSE420:
--- Quote from: couch;3309842 ---Pretty sure all of it needs to be done by the final owner.
--- End quote ---
im trying to find where i read what i said hold up
dont bother trying to buy a lpk from ctd if youre in ca they freak out an yell
BOUNCEHOUSE420:
found it here in post 36... i know ive seen it elsewhere too
http://www.calguns.net/calgunforum/showthread.php?t=110703&highlight=80%25lower
couch:
Handle this... 60%ish 1911 castings. No machining has been done but some parts are good to go with minimal/zero fitting. This is pretty much what mine started out as but it had a few of the holes finished already. I may pick up one or two of these...
http://www.gunco.net/forums/f259/fs-60ish-1911-castings-55389/
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version